Automatic up window not working.

Does anyone know how to work on these automatic windows. My passenger side window will go up and down but when i pull it all the way it will not go up by itself. It just started today. Auto down works. Any suggestions?

I think your battery is going dead, Justin - the hard-start and now this are both signs of diminishing power to those circuits. Check your owners manual on how to re-set the window - I believe you lower it all the way, then hold the switch in the up position for about five seconds after it completely closes. But check the manual; I could be wrong. First thing I'd do is invest in a new battery, however.

Ya.... i'm starting to smell something here...

I smell what your stepping in........

but everthing seems fine now. The driver window works fine and the passenger window works fine except for the automatice up. It started ok all day. Could this be Jarrods fault somehow?

mine did this a few weeks ago. it was my drivers side. started workin fine the very next day...

05SatinGT wrote:but everthing seems fine now. The driver window works fine and the passenger window works fine except for the automatice up. It started ok all day. Could this be Jarrods fault somehow?

Absolutely.

Thanks David i needed someone to say it. Maybe he can chime in and defend himself. Im going to get my manual here in a little bit and see if i can reset the window because the motor is working fine if it goes up and down. Just the memory is messed up i guess or the button.

POWER WINDOW DIAGNOSIS
TECHNICAL SERVICE BULLETIN
Reference Number(s): 06-22-18, Date of Issue: November 13, 2006 FORD:2005-2007 Mustang
Related Ref Number(s): 06-22-18
ARTICLE BEGINNING
ISSUE
Some 2005-2007 Mustang vehicles may exhibit issues with the functional power window features including one touch up, short drop, and bounce back.
ACTION
Follow the Service Procedure steps to correct the condition if the root cause is incorrect or no window initialization of the Smart Window Motor.
SERVICE PROCEDURE
Perform a de-initialization procedure of the smart motor / side window glass, followed by re-initialization procedure.
NOTE: WINDOW RE-INITIALIZATION MUST BE PERFORMED WITH THE DOORS CLOSED.
NOTE: ON CONVERTIBLES, WINDOWS COULD BOUNCE BACK IF THE SIDE GLASS IS OUT OF ADJUSTMENT. REFER TO THE WORKSHOP MANUAL (WSM), SECTION 501-11.
NOTE: CHECK TO MAKE SURE THAT THE DOOR SEAL OR MIRROR SEAL IS NOT ROLLED OVER OR BINDING. ALSO, THAT THERE IS NO OBSTRUCTION IN GLASS SEALING AREA AND THE GLASS FIT AND/OR REGULATOR MECHANICAL FASTENING IS NOT LOOSE.
DE-INITIALIZATION PROCEDURE
1.De-initialization (un-learning) of the smart window motor clears the memory of the module and shuts off the One-Touch UP, Bounce Back and Short Drop functions. 2.The smart window motors can be de-initialized in two (2) different ways: a.Disconnect the battery cable from the battery WHILE THE WINDOW IS MOVING. b.Remove the window motor fuse from the Power Distribution Box WHILE THE WINDOW IS MOVING. 3.After performing one of the above procedures, the smart motor must be re-initialized, see

Page 2 of 2
Initialization Procedure.
INITIALIZATION PROCEDURE
1.INITIALIZATION MUST BE PERFORMED WITH THE DOOR CLOSED! (For convertibles, top and the quarter glass must be in the up / closed position.) 2.From the window switch, perform the following steps without stopping: a.Operate the window UP and stall for 2 seconds. (Hold The Switch) b.Operate the window DOWN and stall for 2 seconds. (Hold The Switch) c.The smart window motor will be initialized and one-touch-UP and Short Drop will be operational. d.Cycle the window glass an additional five (5) times to set the window "Soft Stop" for the down position.
TIP - VOLTAGE RANGE OF OPERATION: 9-16 VOLTS (AT THE MOTOR)
 The smart motor will ONLY function in the 9-16 volt range; if the voltage at the smart motor drops below 9 volts, the window may not function properly or prematurely stop moving
 If the voltage drops below 9 volts while the motor is moving, the motor will become de-initialized (one-touch UP and Short Drop will be inoperable)
 If the motor becomes de-initialized due to low voltage, see initialization procedure, for instructions
WARRANTY INFORMATION
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.

Thanks Greg!! Thats awesome!

Very good info. Thanks Greg.

It worked. I just held the button down for 3 sec and then held up for 3 sec after and it works now. Thanks greg and yancey

i had the same problem with my passenger side window, it will automatically go down but not up

Where or how do i find the who grabbed my balls.

ewwww

The one where the monkeys are in the tree

ewwww again

carcrazy53 wrote:The one where the monkeys are in the tree

Saloon then go to Another Jerbear sighting. Second video. God that is funny.

carcrazy53 wrote:Where or how do i find the who grabbed my balls.

PM SENT!!

Too late. I bought em.